AQLink ATC300 Plus Temperature Controller
The AQLink ATC300 Plus is an intelligent temperature controller ideal for automating heating and cooling of aquariums, terrariums or reptile enclosures. This digital controller maintains accurate temperatures as it regulates between upper and lower limits while displaying the current temperature on the LCD display. Settings are permanently saved after 30 seconds and stored when power is disconnected. The 130cm sensor and slotted mounting holes at the rear make it easy to mount inside or outside the cabinet.
Universal Plug accepts NZ plugs
Senor lead is over 130 cm long and is removable for east replacement.
Senor can work in or out of water.
10A Power with fuse for safety
Set is steps of 0.1 Degree C
Slotted mounting holes
5 modes of operation
Two channels allow for heating and cooling
Control Range: 0 to 70 degrees C
Measuring Range: 0 to 70 degrees C
Adjustment Steps: 0.1 degrees C
Accuracy: +-1 degree C
Input voltage: 220 to 240V 50/60Hz
Control Load Max: 1200W
Press and hold any button for 5 second, the screen will flash and unlock to make program changes. Then press and hold up and down arrows together for 5 second to change the mode. Choose the mode with the down and up arrows and then press [Set] to set temperature parameters. The ATC300+ will be auto save if there is no operation 30 seconds.
P1 – Single Heat Control sets a single temperature range for heating
P2 – Single Cool Control sets a single temperature range for cooling
P3 – Dual Heat Control set an upper and a lower limit for heating
P4 – Dual Cool Control set an upper and a lower limit for both channels
P5 – CH1 Dual Heat Control and CH2 Dual Cool Control
Modes P1, P2, P3 and P4 switches both channels on and off at the same time
Mode P5 allows you to connect both a heater and cooling device to the controller Not recommended for controlling chillers.
Download the Operating Manual